Engineering, 05.08.2020 02:01 jules8022

A Brayton cycle gas engine is analyzed using the cold air standard method. Given the conditions at state 1, pressure ratio (rp), and cutoff ratio (rc) determine the efficiency and other values listed below. The specific heat ratio and gas constant for air are given as k =1.4 and R=0.287 kJ/kg-K respectively. T1 (K) = 337T2 (K) = 647P1 (kPa) = 169rp = 10.3rc = 1.85AV (m3/s) = 1.4Specific Enthalpy at State 1= 337.396Relative pressure at State 1= 2.0849Relative pressure at State 2= 21.5Required:a. Determine the pressure (kPa) at state 2. b. Determine the temperature (K) at state 3.c. Determine the pressure (kPa) at state 3.d. Determine the specific enthalpy (kJ/kg) at state 3.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

You know the right answer?

A Brayton cycle gas engine is analyzed using the cold air standard method. Given the conditions at s...

Questions