Engineering, 12.08.2020 04:01 musicismylove2340

To determine the equivalent moment of inertia of a rigid helicopter component, an engineer decides to run a test in which she pins the component a distance of 40 cm and mounts the component on two springs of stiffness 3.6 times 10^5 N/m. She then provides a harmonic excitation to the component at different frequencies and finds that the maximum amplitude occurs at 50 rad/s. What is the equivalent centroidal moment of inertia predicted by the test?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 06.07.2019 03:30

Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)

Answers: 1

Answer

You know the right answer?

To determine the equivalent moment of inertia of a rigid helicopter component, an engineer decides t...

Questions