Engineering, 12.08.2020 07:01 kkmcfly

Suppose you are working as Requirement Engineer in a renowned software house ABC. You have been given a task to model requirements for a software project of a web based application for client XYZ. Scenario: Online examination is a web portal to establish a network between the students and institute. The system provides a platform for online exam conduction. The examiner visits web site and update question bank which will display as a test to eligible students. Examiners lock or update questions when required. Students attempt exams and portal automatically captures students answers, calculate their score and saves. The administration access the results to determine the pass ratio or to check the performance of the student in particular subject. The Admin of web portal will monitor all the activities and authorize login for both students and examiner with different set of rights. The students are able to get registered, attempt the paper, see the announcements and view their results. You are required to do the following 1) For “Online Examination Portal”, draw Level 1 DFD.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

You know the right answer?

Suppose you are working as Requirement Engineer in a renowned software house ABC. You have been give...

Questions