Engineering, 14.08.2020 15:01 jocelynbeoletto

The velocity components for a flow of an incompressible fluid are given by the following equations:
u=kx (y + z);
v=ky (x + z);
w=-k z(x + y)- 22.
• Determine the value of “k” in order to have a physically possible flow.
• Determine if the flow is steady or not (use the value of “K”, obtained in the first part).
• Determine if the flow is uniform or not (use the value of “K”, obtained in the first part).
• Determine if the flow is rotational or not (use the value of “k”, obtained in the first part). If it
is a rotational flow, compute the magnitude of rotations at a point A which has the following
coordinates: x=1, y=1, z=1.

The velocity components for a flow of an incompressible fluid are given by the following

equation

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

The velocity components for a flow of an incompressible fluid are given by the following equations:...

Questions