Engineering, 15.08.2020 20:01 kashusledbetter
An axle is to spin freely within a bushing. The nominal preferred size is ∅48 mm. What tolerances would you specify for the axle if a shaft basis close running fit was desired? Use a preferred size.
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
An axle is to spin freely within a bushing. The nominal preferred size is ∅48 mm. What tolerances wo...
Social Studies, 03.05.2021 18:00
Mathematics, 03.05.2021 18:00
Mathematics, 03.05.2021 18:00
Health, 03.05.2021 18:00
Mathematics, 03.05.2021 18:00
French, 03.05.2021 18:00
Mathematics, 03.05.2021 18:00
Social Studies, 03.05.2021 18:00
Biology, 03.05.2021 18:00
Mathematics, 03.05.2021 18:00