Engineering, 19.08.2020 18:01 brownvester44

A refrigeration plant operates in Pretoria on refrigerant R134a at an evaporator pressure of 105kPa (gauge) and a condensing pressure of 920 kPa (gauge). There is a sub-cooling of 3K with a superheat of the gas entering the compressor of 8K. The compressor is a four-cylinder reciprocating compressor with a bore of 67mm and a stroke of 57mm with an estimated capacity of 35kW. The compressor is directly coupled to an electric motor running at 1470rev/min and a power consumption of 19,5 kW. Calculate: 1. The clearance volume efficiency if the compressor clearance is 3,6% 2. The actual volumetric efficiency 3. The compression efficiency when the mechanical efficiency is 85% and the motor efficiency 90%.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

A refrigeration plant operates in Pretoria on refrigerant R134a at an evaporator pressure of 105kPa...

Questions