Engineering, 22.08.2020 16:01 achy1905

Experiment No.1 THE WOUND ROTOR INDUCTION MOTOR
OBJECTIVE
To examine the construction of the three-phase wound-rotor induction motor.
EQUIPMENT REQUIRED
Power Supply
Wound rotor Induction Machine,
Electrodynamometer,
AC Ammeter and AC Voltmeter
Connection leads
PROCEDURE
CAUTION!
High voltages are present in this Experiment! Do not make
any connections with the power on! The power should be
turned off after completing each individual measurement!
1. Examine the construction of the Three-Phase Wound-Rotor Induction Motor, paying particular attention to the motor, slip rings, connection terminals and the wiring.
2. Viewing the motor from the rear of the module:
A. Identify the three rotor slip rings and brushes.
B. Can the brushes be moved?
C. Note that the three rotor windings are brought out to thekanivia a slot in the rotor shaft.
D. Identify the stator windings. Note that they consist of many turns of small diameter wire evenly spaced around the stator.
E. Identify the rotor windings. Note that they consist of many turns of slightly larger diameter wire evenly spaced around the rotor.
F. Note the spacing of the air gap between the rotor and the stator.
3. Viewing the front face of the module:
EEL 3003 ELECTRICAL MACHINES 2
A. The three separate stator windings are connected to terminalsandandandand.
B. What is the rated current of the stator windings?
C. What is the rated voltage of the stator windings?
D. The three rotor windings are (wye, delta) connected.
E. They are connected to terminals, and.
F. What is the rated voltage of the rotor windings?
G. What is the rated current of the rotor windings?
H. What is the rated speed and mechanical output power of the rotor?
1. Knowing that the voltage induced in the rotor winding is zero when it is turningat12o synchronous speed, what is the synchronous speed of your motor?
2. Knowing that the equation for synchronous speed is:
Ns= 120f/P
where: Ns- synchronous speed (r/min) f
= power line frequency (Hz)
P number of stator poles
determine the number of poles in your motor.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

You know the right answer?

Experiment No.1 THE WOUND ROTOR INDUCTION MOTOR
OBJECTIVE
To examine the construction...

Questions