Engineering, 02.09.2020 03:01 emcarrell683
Explain why the following acts lead to hazardous safety conditions when working with electrical equipmentA) Wearing metal ring or braceletsB) Being barefootC) Working on a damp concrete floorD) Touching pipes or other grounded conductors while working on electrical equipment. E) Working on electrical equipment with sweaty hands.
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Explain why the following acts lead to hazardous safety conditions when working with electrical equi...
Mathematics, 27.01.2021 21:40
Mathematics, 27.01.2021 21:40
Physics, 27.01.2021 21:40
Chemistry, 27.01.2021 21:40
Mathematics, 27.01.2021 21:40
History, 27.01.2021 21:40
English, 27.01.2021 21:40