Engineering, 10.09.2020 02:01 masie03

Dry air at Ta, in = 30°C, and atmospheric pressure is blown at Va= 1.0 m3/s through a cross-flow heat exchanger in which refrigerant R134a is evaporating at a constant pressure of pR = 345 kPa. The air exits the heat exchanger at Ta, out = 13°C. The tubes and fins of the heat exchanger are both made of copper. The tubes have an outer diameter of Dout, t = 1.64 cm and tht = 1.5 mm tube wall thickness. The fins are circular
with a spacing that leads to 275 fins per meter, an outer diameter of Dout, f = 3.1 cm and a thickness of thf = 0.25 mm. The heat transfer coefficient between the R134a and the inner tube wall is estimated to be R h = 2,500 W/m2
-K. The heat transfer coefficient between the air and tubes and fins is estimated to be a h = 70 W/m2 -K. The total length of finned tubes is L = 110 m.
a) Determine the rate of heat transfer from the air.
b) Determine the value of the heat exchanger conductance for this heat exchanger.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Dry air at Ta, in = 30°C, and atmospheric pressure is blown at Va= 1.0 m3/s through a cross-flow he...

Questions