Engineering, 20.09.2020 09:01 kyleataylor2005

A gas is contained in a closed piston-cylinder device and undergoes the following three processes. Process 1-2: A constant pressure process from 100 kPa and 0.002 m^3 (State 1) to a volume of 0.004 m^3 (State 2)
Process 2-3: A constant volume process with heat transfer to State 3
Process 3-1: A polytropic compression process PV^1.4= constant to state 1.

Required:
a. Determine the pressure and volume at State 3, in kPa and m^3, respectively.
b. Draw the P-V diagram showing the three processes. Label states and identify process directions with arrows.
c. Find the work for each process, in kl.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Ir at sea level and 30°c and 50% relative humidity flows at a rate of 1 kg/s through a cooling coil that has an apparatus dewpoint of 10°c. the air leaves the coil at 15°c. determine the following: 3.1)- relative humidity of the air leaving the coil; 3.2)- moisture content of the air leaving the coil; 3.3)- sensible heat factor; 3.4)- total heat transfer rate; 3.5)- sensible heat transfer rate 3.6)- latent heat transfer rate

Answers: 1

Answer

You know the right answer?

A gas is contained in a closed piston-cylinder device and undergoes the following three processes....

Questions