Engineering, 23.09.2020 16:01 robertrkumar1

Computer programs are classified by the length of the source code and by the execution time. l=> rograms with more t han 150 lines in t he source code are big ( B ). Programs with < 150 lines are little (L). Fast programs (F) run in less than 0.1 seconds. Slow programs (W) r equire at least 0.1 seconds. l\/Ionitor a program executed by a computer. Observe the length of the source code and t he run time. The probability model for this experiment contains the follo\ving information: P [LF] = 0.5, P[BF] = 0.2, and P [BW] = 0.2. What is the sample space of t he experiment?
Calculate the follo, ving probabilities:
A. P [W].
B. P[B].
C. P[WUB].

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

You know the right answer?

Computer programs are classified by the length of the source code and by the execution time. l=>...

Questions