subject
Engineering, 24.09.2020 21:01 Kaitlyn2321

At the end of a power distribution system, a certain feeder supplies three distribution transformer, each one supplying a group of customers whose connected loads are as under: Transformer Load Demand factor Diversity factor Transformer No. 1 10kW 0.65 1.5 Transformer No. 2 12kW 0.6 3.5 Transformer No. 3 15kW 0.7 1.5 If the diversity factor among the transformer is 1.3; find the maximum load on the feeder.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
question
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
At the end of a power distribution system, a certain feeder supplies three distribution transformer,...
Questions
question
Mathematics, 20.01.2021 02:00
Questions on the website: 13722361