1. How have occupations in the machining field changed
over time?
2. How has CAD/CAM changed...
Engineering, 25.09.2020 05:01 jrocklove7825
1. How have occupations in the machining field changed
over time?
2. How has CAD/CAM changed machining maufactoring?
Short answers please, thank you!
Answers: 2
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Mathematics, 24.04.2020 02:02
Mathematics, 24.04.2020 02:02
Mathematics, 24.04.2020 02:02
Physics, 24.04.2020 02:02
History, 24.04.2020 02:02
Mathematics, 24.04.2020 02:02
Social Studies, 24.04.2020 02:02
Mathematics, 24.04.2020 02:02