Engineering, 08.10.2020 14:01 robert7248

In transport problems when we have simultaneous heat and mass transfer, sometimes we quantify the relative strength of the transfer phenomena using the following dimensionless numbers: • Prandtl number (Pr), relative ratio of momentum diffusivity to thermal diffusivity:
• Schmidt number (SC), relative ratio of momentum diffusivity to mass diffusivity:
• Lewis number (Le), relative ratio of thermal diffusivity to mass diffisivity. .
We can easily see that the Lewis number is a ratio of the Prandtl number and the Schmidt number (Le=Sc/Pr). When we are formulating pi terms of transport problems, can all three numbers (Pr, Sc, Le) appear at the same time as three pi terms describing a single transport problem?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

In transport problems when we have simultaneous heat and mass transfer, sometimes we quantify the re...

Questions