Engineering, 08.10.2020 18:01 sincere21

A laboratory furnace wall is constructed of 0.2 m thick fireclay brick having a thermal conductivity of 1.82 W/m-K. The wall is covered on the outer surface with insulation of thermal conductivity of 0.095 W/m-K. The furnace inner brick surface is at 950 K and the outer surface of the insulation material is at 300 K. The maximum allowable heat transfer rate through the wall of the furnace is 830 W/m^2. Determine how thick in cm the insulation material must be.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

You know the right answer?

A laboratory furnace wall is constructed of 0.2 m thick fireclay brick having a thermal conductivity...

Questions