Engineering, 15.10.2020 08:01 ryliepeloquinf

A proposed steam power plant design consists of an ideal Rankine cycle with reheat and regeneration. Steam enters Turbine 1 at P1 and T1 at the rate of m1 and exits at P2. A fraction (y') of the steam exiting Turbine 1 is diverted to an open feedwater heater while the remainder is reheated to T3 before entering Turbine 2. The condenser operates at P4. Saturated liquid exits the condenser and is fed to Pump 1. The outlet of Pump 1 is fed into the open feedwater heater. Saturated liquid exits the feedwater heater and is fed to Pump 2. All turbines and pumps are isentropic. m1 (kg/s) = 50
P1 (Bar) = 160
T1 (oC) = 640
P2 (Bar) = 10
T3 (C) = 600
P4 (Bar) = 1
P5 (Bar) = 0.06

Required:
a. Determine the specific enthalpy (kJ/kg) at the inlet of turbine 1.
b. Determine the specific enthalpy (kJ/kg) at the exit of turbine 1.
c. Determine the specific enthalpy (kJ/kg) at the inlet of turbine 2 .
d. Determine the specific enthalpy (kJ/kg) at the exit of turbine 2.
e. Determine the specific enthalpy (kJ/kg) at the condenser exit.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

1kg of water contained in a piston-cylinder assembly undergoes two processes in series from an initial state where the pressure is 3.0 bar and the temperature is 150°c process 1-2: the water is compressed isothermally to a volume of 0.25 m^3 with 120 kj of work being done to the system. process 2-3: the water is heated at constant volume to a final pressure of 10 bar. a. find the change in internal energy for the system. b. calculate the amount of heat transferred, in kj. c. sketch both processes on a t-v diagram. (196.33 kj/kg, 76.33 kj)

Answers: 1

Answer

You know the right answer?

A proposed steam power plant design consists of an ideal Rankine cycle with reheat and regeneration....

Questions