Engineering, 16.10.2020 14:01 batmandillon21

You are a historian who is compiling information on the changing materials used in a product in one of the categories listed below. Choose a product that uses a variety of materials that have been discussed in this lesson (for example, a car or a tennis racket). Using online or library resources, research past materials used to create the product. Be sure to discuss the materials currently being used for the design and include information on the sustainability of these resources. Your research must also explain why the materials changes were made (for example, safety, cost, or weight). Keep track of your references so that you can document all of the resources used for your report. Anyone got some sources cause I really don't wanna strain my eyes scanning through Wikipedia, this thing has to be 3-to-5 pages long so gimme a n y source you got. <3

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

You know the right answer?

You are a historian who is compiling information on the changing materials used in a product in one...

Questions