subject
Engineering, 16.10.2020 14:01 veronicatrejoaguiler

An inductor with an inductance of 6.8[μH] is connected in parallel with an ideal voltage source. At t = 0, the voltage source has a voltage of zero, and the energy stored in the inductor is zero. The voltage stays zero for 50[μs], and then the voltage of the voltage source increases instantaneously to 5[V]. Then, 10[μs] after that, the voltage source decreases instantaneously to a value of -2[V]. Finally, 20[μs] later the voltage source instantaneously returns to zero, and stays at that value. In summary, the voltage makes three step jumps in value, at 50[μs], at 60[μs], and at 80[μs] after t = 0. Required:
a. Find expressions for the energy stored in the inductor, as a function of time, for the time period 0 < t < 100[μs].
b. Plot the energy stored in the inductor, as a function of time, for the time period 0 < t < 100 [μs].

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
question
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
question
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
question
Engineering, 06.07.2019 03:20
Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.
Answers: 2
You know the right answer?
An inductor with an inductance of 6.8[μH] is connected in parallel with an ideal voltage source. At...
Questions
question
History, 12.10.2019 23:30
question
English, 12.10.2019 23:30
question
Physics, 12.10.2019 23:30
Questions on the website: 13722359