Engineering, 16.10.2020 14:01 tus

Calculate the probability of an event in the prescribed experiment using the classical approach (theoretical for equally likely outcomes) and verify the result by frequency approach (Monte Carlo simulation). In addition, we will perform the same approaches for computing an event of conditional probability. Experiment description: Suppose there are two boxes; in box 1 there are 3 times more green balls than red balls, and in box 2 there are 5 red balls and 8 green ones. We choose one of the boxes at random (that is P(B1) = P(B2) = 0.5), and then 3 balls are randomly taken from that box with replacement. Notice that the actual number of colored balls in box 1 is not given, which causes no problem since the drawings are done with replacement.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

Calculate the probability of an event in the prescribed experiment using the classical approach (the...

Questions