Engineering, 16.10.2020 14:01 Sparkleskeepsgoing
A small, un-insulated closed cylinder with a freely moving piston contains air and is accidentally dropped into a lake and falls slowly to the bottom at 100 m below the surface. Initially, the air in the cylinder is at atmospheric pressure of 100 kPa with a volume of 0.1 m^3and a temperature of 20°C. The lake is also at a uniform and constant temperature of 20C. As the cylinder falls, the air is compressed and there is a heat transfer for the air so that its temperature remains nearly constant at 20°C. Since air can be treated as an ideal gas this implies that the product of pressure and volume is constant (PV = constant) during the process.
Neglect the mass of the piston, friction, air leakage from the cylinder, potential energy and kinetic energy effects for the air and determine the following:
a. Final pressure (kPa) of the air at the lake bottom.
b. Final volume (m) of the air at the lake bottom.
c. Work done (kJ) by the air in the device for entire process.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 06.07.2019 04:30
At steady state, air enters an insulated duct of varying cross-sectional area (similar to a nozzle or diffuser) at 200 kpa, 52°c with a mass flow rate of 0.5 kg/s. at the duct exit, the pressure of the air is 100 kpa, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m^2. assuming an ideal gas model, determine: a)-find the specific volume of the air at the exit, in m3/kg. b)- the temperature of the air at the exit, in k. c)-the velocity of the air at the inlet, in m/s. d)-the inlet cross-sectional area, in m^2.
Answers: 1
Engineering, 06.07.2019 06:10
Aspeed reducer has 20 full-depth teeth and consists of a 20-tooth steel spur pinion driving a 50-tooth cast-iron gear. the horsepower transmitted is 12 at a pinion speed of 1200 rev/min for a diametral pitch of 8 teeth/in and a face width of 1.5 in, find the contact stress
Answers: 3
A small, un-insulated closed cylinder with a freely moving piston contains air and is accidentally d...
Mathematics, 23.10.2020 08:01
Mathematics, 23.10.2020 08:01
Biology, 23.10.2020 08:01
Mathematics, 23.10.2020 08:01
Health, 23.10.2020 08:01
Mathematics, 23.10.2020 08:01
Mathematics, 23.10.2020 08:01
Mathematics, 23.10.2020 08:01
Spanish, 23.10.2020 08:01
Advanced Placement (AP), 23.10.2020 08:01
Mathematics, 23.10.2020 08:01