Engineering, 17.10.2020 03:01 Gyalissunout3526

A 7 in wide polyamide F1 flat belt is used to connect a 2-in diameter pulley to drive a larger pulley with an angular velocity ratio of 0.5. The center-to-center distance is 9 ft. The angular speed of the small pulley is 2000 rev/min as it delivers 2 hp. The service is such that a service factor of Ks of 1.25 is appropriate. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Find F Fi (F)a and 2 assuming operation at the maximum tension limit. (You must provide an answer before moving to the next part) The value of Fis Ibf. The value of F is| Ibf. The value of (Fa is Ibf. The value of F2 is

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

A 7 in wide polyamide F1 flat belt is used to connect a 2-in diameter pulley to drive a larger pulle...

Questions