subject
Engineering, 19.10.2020 20:01 jessb9583

The popularity of orange juice, especially as a breakfast drink, makes it an important factor in the economy of orange-growing regions. Marketed juice has either gone through a process in which it was concentrated, or it may be a not-from-concentrate juice. Frozen concentrated juice is reconstituted before consumption. Although concentrated juices are less popular in the United States than at one time, they still have a major segment of the market. The approaches to concentrating orange juice include evaporation, freeze concentration, and reverse osmosis. Here we examine the evaporation process by focusing only on two constituents in the juice: solids and water. Fresh orange juice contains approximately 10.0 wt% solids (sugar, citric acid and other indigenous ingredients) and frozen concentrate contains approximately 39.0 wt% solids. The frozen concentrate is obtained by evaporating water from the fresh juice to produce a mixture that is approximately 61.0 wt% solids. However, so that the flavor of the concentrate will closely approximate that of fresh juice, the concentrate from the evaporator is blended with fresh orange juice (and other minor additives) to produce a final concentrate that is approximately 39.0 wt% solids. Assume a basis of 400.0 kg of fresh juice fed to the process.

Required:
a. What is the mass of final concentrate produced?
b. What is the fraction of fresh juice that bypasses the evaporator?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
question
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
question
Engineering, 04.07.2019 19:20
Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?
Answers: 3
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
The popularity of orange juice, especially as a breakfast drink, makes it an important factor in the...
Questions
Questions on the website: 13722367