Engineering, 20.10.2020 18:01 hannahrasco4051
What is the cutting speed in surface feet per minute of in 20-in bandsaw if the wheel turns at 800 RPM run your answer to the nearest 10-ft convert your rounder answer to meters per minute from this answer to the nearest 10 meters use the space provided for your calculations This is for my woods class pls help asap
Answers: 3
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
What is the cutting speed in surface feet per minute of in 20-in bandsaw if the wheel turns at 800 R...
Mathematics, 04.03.2022 02:50
History, 04.03.2022 02:50
Mathematics, 04.03.2022 02:50
English, 04.03.2022 02:50
Social Studies, 04.03.2022 03:00
Spanish, 04.03.2022 03:00
History, 04.03.2022 03:00