subject
Engineering, 20.10.2020 20:01 philliple481

A pork-processing facility is considering installing either a storage facility or a holding pond. A biosystems engineer has been hired to evaluate the economic trade-offs for the two alternatives. The engineer estimates the cost of the storage facility to be $213,000, with annual costs for maintenance to be $3,200 per year. She estimates the cost of the pond to be $90,000, plus $45,000 for pumps and piping; annual operating and maintenance costs for the holding pond are estimated to be $8,500. The engineer estimates the life of the storage facility and the pond to be around 20 years but is concerned about the accuracy of this estimate. She decides to do a sensitivity analysis. Click here to access the TVM Factor Table Calculator
Develop the equation she should use to determine how sensitive the economic decision is to changes in life. Use a MARR of 15%
Equation that can be used to determine the sensitivity is
Determine which alternative is preferred for lives ranging from 15 to 25 years in 1 year increments:
Life Difference Preferred Alternative
15
16
17
18
19
20
21
22

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 19:10
Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.
Answers: 1
You know the right answer?
A pork-processing facility is considering installing either a storage facility or a holding pond. A...
Questions
question
Mathematics, 17.12.2020 14:00
question
Mathematics, 17.12.2020 14:00
question
English, 17.12.2020 14:00
question
Mathematics, 17.12.2020 14:00
question
Mathematics, 17.12.2020 14:00
question
English, 17.12.2020 14:00
Questions on the website: 13722363