subject
Engineering, 21.10.2020 16:01 asheeee58

: Consider a wing with a rectangular planform mounted in a low-speed subsonic wind tunnel. The wing model completely spans the test section so that it may be considered an infinite wing. If the wing has a NACA 4412 airfoil section (see textbook Appendix) and a chord of 0.4, calculate the lift, drag, and moment about the quarter-chord per unit span when the freestream air pressure is 98 kPa, the freestream temperature is 280 K, the freestream velocity is 38 m/s, and the viscosity is 1.7894 ∙ 10−5 kg/(m ∙ s) at the following angles of attack: a) 5° b) 16° c) -2

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
: Consider a wing with a rectangular planform mounted in a low-speed subsonic wind tunnel. The wing...
Questions
question
Mathematics, 24.03.2020 21:43
question
Mathematics, 24.03.2020 21:43
question
History, 24.03.2020 21:43
Questions on the website: 13722361