Engineering, 22.10.2020 14:01 bevanscory123

A detailed solution with reasoning is demanded... (a) By applying the relevant knowledge, the Total Solidification Times(TST) of three casting
shapes are to be calculated and compared: (1) a sphere with diameter 1⁄4 10 cm, (2) a cylinder with
diameter and length both 1⁄4 10 cm, and (3) a cube with each side1⁄410 cm. The same casting alloy
is used in the three cases. Determine the relative solidification times for each geometry. If the mold
constant 1⁄4 3.5 min/cm2 in Chvorinov’s rule, compute the total solidification time for each casting.
(b) Based on the results of part (a), which geometric element would make the best riser and why?
Present an analysis-based comment on the outcome.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

You know the right answer?

A detailed solution with reasoning is demanded... (a) By applying the relevant knowledge, the Total...

Questions