1333
The purpose of a relay is to switch a large main current, using a small control current.
...
Engineering, 26.10.2020 21:30 yesmi
1333
The purpose of a relay is to switch a large main current, using a small control current.
A small switch can handle the control current without burning out. The relay contacts
switch the current to the load and are large enough to handle this.
Om
OFF
20M
22
2M
30
A standard relay has four electrical terminals.
These are: (1) main current input, (2) main current output, (3) control current input,
and (4) control current output.
- 200K
87
20K
For example, relays can be used to switch current to the starter solenoid, horn, and
headlamps.
200
1)
16.COM
VĪ©
Measure the control current. This is the current that flows through the coil.
mA
Answers: 3
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg ā¢ k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
Computers and Technology, 25.01.2020 00:31
Social Studies, 25.01.2020 00:31