Engineering, 31.10.2020 09:40 05eviebee

Use the following clues to help fill in the chart on the next page. Put an X in the spaces that are INCORRECT and Highlight the CORRECT
1 The wizard with the lavender wand is in Ravenel or Sparrowan, and earned 50 or 60 points
2. Gorgonscale earned 10 points less than Sparrowman
3 Lynn scored 20 points less than the wizard with the incense wand.
4. Timmy scored 70 or 80 points. He is in Gorgonscale or Hydraden
5. Among Bennie and the wizard from Sparrowan, one earned 70 points and the other has the lavender wand.
6. The mandragore wand belongs to Edward or to the House of Hydraden
7 Ravenel didn't earn 60 points and Edward is not among it's wizards
8. Bennie scored 10 points more than Edward
9. The wizard with the mandragore wand didn't earn 70 points.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

Use the following clues to help fill in the chart on the next page. Put an X in the spaces that are...

Questions