subject
Engineering, 06.11.2020 16:50 fufnun3379

* Two thermal units are operating parallel at 50 Hz. Unit 1 has a rated output of 400 MW and 2% speed-drop characteristic. Unit 2 has a rated output of 500 MW and 3% speed-droop characteristic. The total load increases by 150 MW. What is the common frequency change

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
* Two thermal units are operating parallel at 50 Hz. Unit 1 has a rated output of 400 MW and 2% spee...
Questions
question
Mathematics, 22.06.2021 04:20
question
Mathematics, 22.06.2021 04:20
question
English, 22.06.2021 04:20
Questions on the website: 13722359