Engineering, 07.11.2020 20:50 jortizven0001

Show & sell can advertise its products on local radio or television(TV). The advertisement budget is limited to $10,000 a month. Each minute of radio advertisement costs $15 and each minute of TV commercials costs $300. Show & sell likes to use radio advertisement at least twice as much as TV. In the menatime, it is not practical to use more than 400 minutes of radio advertisement a month. Past experience shows that TV advertisement is estimated to be 25 times more effective than that of radio. a) Determine the optimum allocation of the budget to radio and TV advertisement.

b) Determine the worth per unit of increasing the monthly limit on radio advertisement.

c) If the monthly budget is increased to $15,000, use the unit worth measure to determine the resulting optimum measure of advertisement effectiveness.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

Show & sell can advertise its products on local radio or television(TV). The advertisement budge...

Questions