Engineering, 09.11.2020 01:20 tmrsavage02p7cj16
In a mixer (see image), due to use, a weight of 10 kg of cement was accumulated. This caused it to start to vibrate out of the ordinary and damage the bearing. Additionally it damaged an internal paddle. This was repaired with 100 grams of solder. The repair zone is located 45 cm from the center of rotation of the main shaft which is 3 ”thick. On this axis there is another pallet that has the same dimensions (60 cm long from the axis of rotation) and that is in the opposite direction to the damaged pallet. Mixer works at 20 RPM As an engineer, what is the solution to get the mixer up and running again?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
You know the right answer?
In a mixer (see image), due to use, a weight of 10 kg of cement was accumulated. This caused it to s...
Questions
English, 30.05.2020 22:02
Mathematics, 30.05.2020 22:02
Mathematics, 30.05.2020 22:02
History, 30.05.2020 22:02
Chemistry, 30.05.2020 22:02
English, 30.05.2020 22:02
Computers and Technology, 30.05.2020 22:02
