Engineering, 10.11.2020 01:00 brendaesme

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of friction, μ , of the surface of the incline plane is 0.3. The frictional force is = μ where is the normal force. The weight of the block is W. Assume the acceleration due to gravity is 9.8 m/ 2 (a) Provide the expression for the component for the Weight force in the direction along the incline plane.
(b) Provide the expression for the component for the Weight force in the direction perpendicular to the incline plane.
(c) Provide the expression for the normal force in terms of W.
(d)
Provide the expression for in terms of W.
(e) Provide the equation for the sum of the forces in the direction along the incline plane (include appropriate signs).
(f) Provide the equation for the sum of the forces in the direction perpendicular to the incline plane (include appropriate signs).
(g) What is the value for acceleration of the block along the incline plane?
(h) How far (in meters) will the block slide in 10 seconds if it is released from rest?

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of f

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

A block is sliding down an incline of 60 degrees as shown in the figure below. The coefficient of fr...

Questions