Engineering, 10.11.2020 14:00 dmurdock1973

Q11 Figure Q11 shows an amplifier circuit, where the BJT Qı has the following parameters Is = 10-15 A, B = 100, VA = 100 V. The two MOSFETS, M, and M2, are identical and
have the following parameters: VTHP=-1 V, 1= 0, K = 0.5 mAV-2.
V = 10 V
Vi = 5V
M
M2
Ri
35 kΩ
RREF
RS
WH
100 Ω
Rour
Vs
Vo
Rin
R
100 S2
R
V
Fig. 211
BJT Q1 is known to operate in forward active mode.
(a) Determine the value of RREF to provide a de collector current of 1 mA to BJT Qı
(6 marks)
(6) Determine the value of R2.
(2 marks)
(c) Identify the amplifier configuration,
(1 mark)
(d) Determine the small-signal model parameters of Q1, i. e., gm.91, rap, and ro. pl
(3 marks)
(e) Determine Rin and Rour of the two-port network of the amplifier
(4 marks)
(f) Determine the gain ve/vs of the amplifier
(2 marks)
(g) If the supply voltage V, is reduced to 4 V, discuss the effects on the amplifier circuit
Assume no other changes in the amplifier circuit.
(2 marks)

Q11 Figure Q11 shows an amplifier circuit, where the BJT Qı has the following parameters

Is = 10-

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

You know the right answer?

Q11 Figure Q11 shows an amplifier circuit, where the BJT Qı has the following parameters Is = 10-15...

Questions