Does anyone understand philosophy and can explain pragmatism in the philosophy of religion ?

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c

Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.