Engineering, 14.11.2020 01:00 EstevanOtero7361
GIVE ME A ZOOM LINK/PASS/ID FOR FREE POINTS, IF NOT ILL REPORT YOU!!!
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
GIVE ME A ZOOM LINK/PASS/ID FOR FREE POINTS, IF NOT ILL REPORT YOU!!!...
Questions
Computers and Technology, 23.11.2020 14:00
English, 23.11.2020 14:00
Geography, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
Physics, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
English, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
Biology, 23.11.2020 14:00
Mathematics, 23.11.2020 14:00
English, 23.11.2020 14:00
