Engineering, 17.11.2020 23:40 lefarrioe8621

The amount of moisture is represented in the Wildfire Explorer by the drought level. Click the Terrain Setup button to adjust the drought level. Then, place a spark in each zone and run the model.

Watch how the wildfires spread in each zone.

How does drought level affect the spread of wildfires?

Vegetation with a low drought level will burn quickly
Vegetation with a high drought level will burn quickly
Vegetation with a high drought level will burn slowly
The drought level of vegetation has little effect on the spread of wildfires

What side of the fire triangle does drought affect?

Oxygen
Heat
Fuel

Now, experiment with wind speed and direction. You can change the wind speed and direction on the second page of the Terrain Setup menu.

How does wind speed and direction affect the spread of wildfires?

What side of the fire triangle does wind correspond to?

Oxygen
Heat
Fuel

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

You know the right answer?

The amount of moisture is represented in the Wildfire Explorer by the drought level. Click the Terra...

Questions