Engineering, 24.11.2020 06:10 andydiaz1227

Let the ends of a copper rod 100 cm long be maintained at 0 degrees Celsius. Suppose that the center of the bar is heated to over 100 degrees. Celsius by an external heat source and that this situation is maintained until a steady state results. Find the steady state temperature distribution. At t = 0 [after steady state part (a) has been reached], let the heat source be removed. At that the same instant let the end x= 0 be placed in thermal contact with a reservoir at 20 degree Celsius, while the other end remains at 0 degree Celsius. Find the temperature as a function of time u (x, t).

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

You know the right answer?

Let the ends of a copper rod 100 cm long be maintained at 0 degrees Celsius. Suppose that the center...

Questions