Engineering, 25.11.2020 03:10 ianball025

What is the difference between a negotiated price bidding process and a low-bid bidding process? In a negotiated price process, the price is set and the first contractor to bid for the work gets the job, but in a low-bid process, the
contractor with the lowest bid wins.
O
In a negotiated price process, the contractor that can show the best qualifications wins, but in a low-bid process, the contractor with the
lowest bid in terms of price wins.
In a negotiated price process, the price is flexible, but in a low-bid process, bidding continues until a bidding contractor bids low enough to
reach a set price for the project.
O In a negotiated price process, the projects are large, but in a low-bid process, the projects are small with smaller budgets,

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

You know the right answer?

What is the difference between a negotiated price bidding process and a low-bid bidding process? In...

Questions