Engineering, 25.11.2020 14:00 wrightdarius78

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film is exposed to stagnant 100% O2 gas maintained at 1.5 atm. Oxygen gas is sparingly soluble in the silicone polymer film, with the solubility relationship given by Ca = S* Pa with S = 3:16 g mol O2/m3 silicone atm O2 at 298 K. Initially, there is 0.39 g mol O2/m3 uniformly dissolved in the film. The diffusion coefficient of O2 in silicone is 1 × 10-11 m2/s at 298 K. a. At a very short time of 10 s, O2 does not penetrate very far into the silicone polymer film. Under this physical situation, what is the flux of O2 into the surface of the silicone polymer film at this time? b. At a much longer time, the dissolved O2 concentration in the silicone polymer film at the polymer/inert interface is now 3.0 g mol/m3. How long will it take to achieve this concentration?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film i...

Questions