subject
Engineering, 04.12.2020 06:30 sierradanielle9280

A convective kerosene heater is tested in a well-mixed 60 m3 chamber having an air exchange rate of 0.3 ach. After one hour of operation, the nitric oxide (NO) concentration reached 3 ppm. Treating NO as a conservative pollutant, estimate the NO source strenght of the heater (in mg/hr).
Assume: 25 oC and 1 atm

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50Β°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 Β°c. sutherland constant for air is 111k
Answers: 3
You know the right answer?
A convective kerosene heater is tested in a well-mixed 60 m3 chamber having an air exchange rate of...
Questions
question
Social Studies, 26.02.2021 16:30
question
Physics, 26.02.2021 16:30
question
Mathematics, 26.02.2021 16:30
Questions on the website: 13722367