Engineering, 06.12.2020 05:00 alejosy50

PLEASE HELPPP A gaseous stream containing 20.0 mole% ethanol and 80.0 mole% air is to be cooled from 60.0 degrees celsius to 9.65 in a condenser at the constant pressure of 1 atm to liquefy some of the ethanol. The gas stream entering the condenser has a pressure of 1.00 atm, flows at a rate of 10.0 mole/s at 60.0 degrees, is well above the saturation temperature (42.4 degrees celsius). As a result of the cooling, 1.75 mole/s of liquid ethanol (Tbp = 78.5 degrees) leaves the condenser as a liquid stream in addition to a gas stream containing all of the materials which were not liquefied. What is the rate of heat transfer in the condenser?

Show: flow chart, energy balance, reference state, and enthalpy table.

For ethanol: Cp = 0.06134 as a gas

Cp = 0.1031 as a liquid

For air: Cp = 0.02894 kJ/ (mol. degress celsius)

NOTE: ALL TEMPERATURE VALUES ARE IN CELSIUS

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 06.07.2019 04:30

At steady state, air enters an insulated duct of varying cross-sectional area (similar to a nozzle or diffuser) at 200 kpa, 52°c with a mass flow rate of 0.5 kg/s. at the duct exit, the pressure of the air is 100 kpa, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m^2. assuming an ideal gas model, determine: a)-find the specific volume of the air at the exit, in m3/kg. b)- the temperature of the air at the exit, in k. c)-the velocity of the air at the inlet, in m/s. d)-the inlet cross-sectional area, in m^2.

Answers: 1

Answer

Engineering, 06.07.2019 05:30

Both elongation and reduction of area represent the ductility of a specimen. are there any differences between these two in terms of material properties?

Answers: 3

Answer

You know the right answer?

PLEASE HELPPP A gaseous stream containing 20.0 mole% ethanol and 80.0 mole% air is to be cooled fro...

Questions