Engineering, 06.12.2020 14:00 krishawnnn

Digital Timer Requirement
In this part, you will design program for "DIGITAL TIMER" with countdown or count up functionality from 00 to 60. The counter will count from a preset value entered by the user (pre_set ) which can take from 00 to 60.
Features
• You may Use fix values to set the counting down value (pre_set).
• Use hotkeys to change between counting down by 1, up by 1, down by 2 or up by 2.
• Make sure that you define each digit as separate variable.
o So if we have 59 the first digit will be 9 and the second digit will be 5.
• Use hotkeys to choose :
o Preset the value to user number.
o Reset the counter to 00
o Start the counting.
• Use one hotkey to start the counting so that the first press will start counting the second press will stop the counting and the number will stay the same.
• Choose speed for the counting (hotkey).
o Fast counting speed.
o Slow counting speed.
• You should show an indication that the timer is finished, which is making output with one bit blinking on and off.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Digital Timer Requirement
In this part, you will design program for "DIGITAL TIMER" with cou...

Questions