Engineering, 07.12.2020 14:00 naenaekennedybe

Page 10 (25) Choose the CORRECT answer
(a) Hydraulic and pneumatic systems work as back up to each other. When one system fails, the other is used to move the actuators.
(b) Hydraulic system is pressured by engine driven pumps or air driven pumps.
(c) Major subsystems of Auxiliary Power Unit (APU) System are: Gas turbine, Compressor for pneumatic power and generator for electrical DC power.
(d) APU is located at the tail end of aircraft and so its weight is very useful to keep a nose up tendency during the flight.

(26) Choose the CORRECT answer
(a) Some Avionics systems are: Displays and controls, Communication system, Navigation system, Cabin entertainment system, Weather radar and Flight management system.
(b) The hot air from the engine, called bleed air is used to heat the leading edge of the wing to prevent the formation of ice and so there is no anti-ice system needed for the engine itself.
(c) Design of complex systems of aircraft is not carried out by following ARP standards as they are only recommended practices.
(d) Emergency power system allows safe flight and landing in case of a total power loss that is when all Engines and APU are inoperative.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

You know the right answer?

Page 10 (25) Choose the CORRECT answer
(a) Hydraulic and pneumatic systems work as back up to...

Questions