Engineering, 10.12.2020 02:10 jweldene12

Edit Tools Help
1. In your words, what is the binary system?
Binary Numbering ..
2. A byte contains 8 bits of data, What is the highest possible number that can be
represented in a byte? Explain your answer.
3. Write each of the following in a byte using binary:
a. Birth Month (as a number):
b. Birth Day of the month):
I c. Age:
4. A DC motor receives voltage from an 8-bit, 5V Arduino. If the voltage signal ranges from
0-5V, by how much does the voltage increase as the byte increases by 1? (HINT: Think
about the maximum number in a byte and the maximum voltage)
5. For the DC motor in question 4, if you want to send 3V to the motor, then to what value
should you set the Arduino Pin?
6. Write the answer from question 5 as a byte in binary.
7. Determine how many bits the Temperature sensor sends. (HINTA find the maximum
voltage sent by the sensor and find the value read by the Arduino at that voltage.)
DEC
9
w

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

Edit Tools Help
1. In your words, what is the binary system?
Binary Numbering ..
...

Questions