Engineering, 13.12.2020 20:50 joThompson

During the semester, we have studied a wide range of topics related to behavior in organizations. Each module in the course began with a survey that examined your assumptions regarding its associated domain area. Material for that module either confirmed or challenged your assumptions. For this discussion forum (which is graded), choose one course module where your assumptions were confirmed and one where your assumptions were challenged.

For the module where your assumptions were confirmed:

Explain how and why they were confirmed and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways

For the module where your assumptions were challenged:

explain how and why they were challenged and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

During the semester, we have studied a wide range of topics related to behavior in organizations. Ea...

Questions