Engineering, 13.12.2020 23:40 chandlergward8

I need help with creating a Residual Valuation Calculation for a site I have chosen for my 'Office to Residential Conversion assignment' which is due on 18th December 2020. See the site details below: Chosen Site:-
Office for sale in Unit 10, Freeport Office Village, Braintree, Essex CM77
£550,000 (£240.91/sq. ft)

Purpose of the site: Convert from its current use as an office to a residential building.
Assignment Tasks:
-Produce a detailed residual method valuation with references.
-Research comparable resale values or rental income that can be derived from the proposed development
-Demonstrate knowledge and understanding of the overall development process
-Create a development plan showing disposal and use, and design of the development

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

I need help with creating a Residual Valuation Calculation for a site I have chosen for my 'Office t...

Questions