Engineering, 14.12.2020 01:00 alex7881

Please Help ASAP Follow the steps below to calculate the reaction forces at points A and C.

1. List the Static Equilibrium equations.
2. List all known and unknown forces acting and reacting on the truss structure. Label the direction of the force with an arrow. . Find the moment forces. Determined from Pin A .
3. Use the moment static equilibrium equation acting upon pin A to solve for
4. Solve for unknown reaction force in the x direction (). Use the sum of forces in the x direction equilibrium equation.
5. Solve for unknown reaction forces in the y direction. Use the sum of forces in the y direction equilibrium equation.

**Please Help ASAP**

Follow the steps below to calculate the reaction forces at points A and C.
1

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

**Please Help ASAP** Follow the steps below to calculate the reaction forces at points A and C.

Questions