Engineering, 15.12.2020 02:00 100738

Assignment V: Discussion Forum-Take-Aways 33 unread replies.33 replies. During the semester, we have studied a wide range of topics related to behavior in organizations. Each module in the course began with a survey that examined your assumptions regarding its associated domain area. Material for that module either confirmed or challenged your assumptions. For this discussion forum (which is graded), choose one course module where your assumptions were confirmed and one where your assumptions were challenged. For the module where your assumptions were confirmed: Explain how and why they were confirmed and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways For the module where your assumptions were challenged: explain how and why they were challenged and list three specific ways in which your knowledge of organizations was enhanced--that is, three take-aways"leadership"

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

You know the right answer?

Assignment V: Discussion Forum-Take-Aways 33 unread replies.33 replies. During the semester, we have...

Questions