subject
Engineering, 16.12.2020 02:50 dre2544

Look at the first photo of an area that just experienced a wildfire. In the next few years, what is the likelihood of another wildfire in this same area?

Low
Medium
High

Explain your answer using the Fire Triangle.


Look at the first photo of an area that just experienced a wildfire.

In the next few years, what

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
You know the right answer?
Look at the first photo of an area that just experienced a wildfire. In the next few years, what is...
Questions
question
Mathematics, 18.02.2021 06:20
question
Computers and Technology, 18.02.2021 06:20
question
Mathematics, 18.02.2021 06:20
question
Mathematics, 18.02.2021 06:20
question
Arts, 18.02.2021 06:20
question
Mathematics, 18.02.2021 06:20
question
Mathematics, 18.02.2021 06:20
Questions on the website: 13722367