Engineering, 16.12.2020 20:50 yasminothman02
3.
If the variable step is set to equal 5 and then the code reads step = step + 2, what will step now equal?
0
2
5
7
Answers: 1
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
3.
If the variable step is set to equal 5 and then the code reads step = step + 2, what will step n...
Social Studies, 01.07.2019 02:00
Social Studies, 01.07.2019 02:00
History, 01.07.2019 02:00
Mathematics, 01.07.2019 02:00
Advanced Placement (AP), 01.07.2019 02:00
Chemistry, 01.07.2019 02:00
Physics, 01.07.2019 02:00
Mathematics, 01.07.2019 02:00
Mathematics, 01.07.2019 02:00
Health, 01.07.2019 02:00